Solder Bike Cable Ends

The cable should now be dipped in soldering flux d before soldering e.

Solder bike cable ends.

Anyway if you want to solder the ends be sure to clean the cable first use flux and get the cable end hot before trying to solder it. Kiwav universal throttle clutch brake parking brake cable end repair travel emergency repair kit motorcycle bicycle atv. If that makes the cable too short you ll have to toss it and start over. If it gets red the end of the cable will have to be trimmed off.

Get it as soon as wed sep 30. Free shipping on your first order shipped by amazon. Heat shrink tubing or even gum is lots easier. Be careful not to fray the cut end of the cable.

I use a bic lighter which resides in my tool box to heat the end of the cable then melt a little solder on it. Preassemble your cable parts and check for size before you solder. This is accomplished by first threading the inner cable through the nipple photo b before splaying the cable s wires c. Use good quality sharp wire cutters dykes for cutting the cable.

Rotary 10 pack 14819 universal cable wire stop z bend. I stick the cable end in a small can of flux. Dip the tip in some soldering flux not too far in as the solder will flow as deep as the flux goes heat the cable starting at just the tip since that is really where you want the majority of the solder to penetrate anyway add solder a little bit at a time so the end of the cable doesn t get bulky with solder.