Uniclic Engineered Hardwood Flooring Installation Instructions

The side of plank is thentapped lightly against the previously laid row.

Uniclic engineered hardwood flooring installation instructions.

Put a staple every 6 to 8 inches. End joints on adjoining rows should be offset by no less than 6. Manufacturers recommend that you install the planks with the tongue side against the wall and the groove side facing into the room. Instructions also availablevia cell phone using the qr code on the pre installation check list found in the box.

Align this plank and lock the side into place against the first plank in row 1. The next plank is aligned with the end joint first into the previously plank in row 2. End joints on adjoining rows should be offset by no less than 6. Align this plank and lock the side into place against the first plank in row 1.

Align this plank and lock the side into place against the first plank in row 1. Uniclic locking technology for flooring panels. This installation method is identical to staple down only the fastener and fastening tool differ. For 3 8 engineered floors the minimum staple cleat is 1 for 9 16 engineered floors the recommended nail staple length is 1 1 4 1 1 2 long.

Engineered hardwood guide to choosing a hardwood floor 10 things to know about hardwood installation how to clean hardwood room inspiration guide. All installation instructions must be followed for warranties to be considered valid. Pre inspect the job site prior to delivery of the floor to ensure the structure is suitable for hardwood flooring installation using the following. Engineered floor guns nail or staple guns used for engineered floors will be 18 or 20 gauge based on the guns manufacturer.

Locking profile for both sides of the panels. Installation instructions warranties brochures certifications sell sheets videos. Uniclic the traditional glueless locking technology. The next plank is aligned with the end joint first into the previous plank in row 2.

Use a pneumatic flooring stapler to drive staples through the groove at a 45 degree angle image 1. Both solidwood and tecwood floors are a beautiful addition to your home and we re excited to help you get your installation started. Epic plus engineered hardwood nailers staplers. The side of plank is then tapped lightly against the previously laid row.

With a nail down engineered hardwood floor follow the same subfloor preparation steps as above including underlayment and laying spacers around the room s perimeter to maintain the manufacturer s recommended expansion gap. The next plank is alignedwith the end joint first into the previ ously plank in row 2.