Under deck ceiling systems provide an all in one drainage and ceiling finish that is particularly suitable for areas beneath a deck that are high enough off the ground to provide a sheltered outdoor living space below.
Underside of garage roof decking.
Position the foam board between the rafters and push it upward until it fits snugly against the underside of the roof deck.
Most unvented attics incorporate spray polyurethane foam spf on the underside of the roof deck and attic walls.
Special framing and moisture protection measures can provide mounting points for overhead light fixtures and ceiling fans.
Warm wet air rises and meets the cold roof and cools.
The portion of interior ceiling i am concerned with faces west so i thin it would make a difference to the garage temps if i.
If the span under your deck is 12 ft for example the purlin at the outer end of the deck should be 3 in.
This construction approach was first used in the 1970s and it has been implemented much more widely since it was first included in the international code council s icc model building code in 2007 irc section 806 4.
The skeleton of a roof is formed with rafters or trusses generally spaced 16 inches or 24 inches apart from the center of one rafter to the center of the next.
The snugness of the foam itself should be sufficient to hold the strips.
My question is about the unfinished interior of the garage.
Lower than the purlin along the house 12 x 1 4 3.
That excess moisture ends up as drops of condensation on the roof.
The unfinished garage ceiling has 2x4 joists on 24 centers.
Essentially condensation occurs at night when the temperature inside a building is warmer than outside.
To stabilize the rafters support the roofing material and hold the entire roof together roof sheathing is installed.
I am wondering if it is okay to hang insulation up against the inside of the roof in the garage.
As it cools it can t hold as much moisture.
To provide drainage the panels should slope toward the outside edge of the deck about 1 4 in.