The unit has worked without further problems following replacement of the fuse.
Truma water heater problems.
Water escaping at pressure relief.
If the relays are faulty this can reduce the power of the heater.
Adjust the water pump pressure to a.
Water pressure in water system too.
The truma aquago basic does not have frost protection and should not be used or filled with water when there is a danger of freezing.
They are known to fail for no apparent reason.
My model has settings at 500w 1kw and 2kw.
Manuals instructions installation and operating instructions truma aquago basic comfort comfort plus 7 55 mb.
I have recently had one fail on a truma system that was less than 9 months old.
If you are lacking heat by searching the web i found that there are several problems that seem to afflict these heaters 1 relays not working.
Perhaps the truma guys will chime in here.
However the aqua go has a small tank in it which will likely reduce temperature swings compared to other tankless water heaters.
I first noticed the problem when the carpet near the boiler door seemed to be wet.
Most truma hot water systems have a small 10 amp.
Maximum of 65 psi 4 5 bar.
A call to truma uk revealed that the part had changed in the late 90 s and i would need to give them the boiler serial number.
If the water system is connected to a cen.
Ceramic slow blow fuse fitted on the control pcb.
On taking a closer look i noticed that water was dripping from the hot water outlet connection.
Truma water heater problems.
Tral water supply higher than 65 psi 4 5 bar rural or urban connection a pressure reducer must be used.