Sunsetter Awning Remote Flashes Red Light

Press and hold my for 8 seconds the light should blink the entire time.

Sunsetter awning remote flashes red light.

Verify that the red led light on the remote transmitter comes on when you press and hold one of the buttons marked with an up arrow a down arrow or the word my if the red light does not come on at all or blinks for less than five seconds you will need to replace the battery with a new battery 3v lithium cr2430. If not replace the cr2430 battery. If the red light does not come on at all or blinks for less than 5 seconds you will need to replace the battery see care and maintenance section on page 15. The multi channel remote transmitter must be programmed to the light control box the first time the led light system is plugged in.

Sunsetter awnings are motorized units that extend over windows or porches to provide extra shade on sunny days. Sunsetter recommends channel 1 be used to operate your awning and channel 2 be used to operate your led light system unless you did not purchase a motorized awning then use channel 1 to operate your led light system. Manual motor control bar. Electric drill use gloves and eye protection center punch hammer pencil tape measure.

Press the neutral middle button on the transmitter. Verify that the red light on the remote transmitter comes on when you press and hold the button. If it does continue to the next step.