7 180 mm max.
Stair tread nosing depth.
A step tread is the flat horizontal surface that you walk on.
The tread depth is the distance from the front edge or nosing a tread projection that overhangs the riser below of one step to the front edge or nose of the next step measured horizontally.
Stair tread depths shall be 11 inches 279 mm minimum.
The stair riser must measure 8 to 8 1 4 inches high.
Unfinished red oak tread nosed return is made for interior stair construction from attractive natural oak.
2 steps for stairs referred to in sentence 1 shall have a rise between successive treads not less than 125 mm and not more.
5 13 mm max.
Styles a and b are for use on wood or concrete stairs.
Beveling of nosings shall not exceed 1 2 inch 12 7 mm.
A nosing is not required where the tread depth is a minimum of 11 inches 279 mm.
For concrete stairs use concrete anchors with 4 screws.
Treads and risers 1 except as permitted for dwelling unitsand by sentence 3 4 7 5 1 for fire escapes steps for stairs shall have a run of not less than 255 mm and not more than 355 mm between successive steps.
1 5 38 mm max.
A nosing is not required where the tread depth is a minimum of 11 inches 279 mm.
Unfinished red oak tread the surewood lnl 13 in.
The surewood lnl 13 in.
Staircase tread run depth.
Screw nosing into place to protect the front portion of the stair and provide a slip resistant surface.
10 to 11 inches minimum.
For a typical staircase the stair tread must measure 8 1 4 inches to 9 inches deep measure 1 inch thick or more and have a maximum 1 1 2 inch deep nosing.
For stair treads less than 9 inches deep secure a new deeper tread directly on top of the existing tread.
It is sold unfinished allowing you to finish it to match other red oak stair parts or decor.
Attaches to the ends of plain treads to create a return tread in open stringer stair designs.
Stair tread nose curve radius 9 16 or 1 2 in some codes.
The stair tread depth shall be measured horizontally between the vertical planes of the foremost projection of adjacent treads and at right angle to the tread s leading edge.
The stair tread depth red arrow is measured from the forward edge of the step nose or edge of the step above out to the leading edge of the step being measured.
So since the minimum tread size is 10 a nosing will extend the tread depth to between 10 3 4 and 11 1 4.
11 280 mm min.
Stair tread nosing stair tread nosing projection past vertical riser below 3 4 to 1 1 2 required on stairs with solid risers.
4 100 mm min.
Construction adhesive sold separately is for use between nosing and the front edge of the stair to prevent cracks.