Spinner Small Parts Deburring Machine

Repeat until media and parts are fully separated.

Spinner small parts deburring machine.

Non ferrous metals including aluminum brass stainless steel and titanium can be deburred and fine finished however most steels certain plastics and precious metals can also be processed without any effect on tolerances or damage to delicate areas and as a result will achieve a bright. From small job shops to high production runs the spinner small parts deburring system will dramatically reduce deburring costs while improving surface finish. Typical deburring cycles are only 15 20 minutes and all spinner machines allow variable intensity and duration of deburring cycles using the programmable control panel. Turn on the machine for about 10 seconds.

Place media and parts into the separation container. Your parts should be trapped in the top of the separation container. All parts are automatically demagnetized at the end of the deburring cycle. The magnetically activated media deburrs internal cavities slots holes and even blind holes.

Hand deburring small parts is often a tedious and labor intensive process let us reduce your company s overhead with this proven technology. The pins will be pulled through the separation container to the bottom. The revolutionary magnetic deburring process utilized by the spinner deburring machine has saved manufacturers tens of thousands of labor hours while producing parts free of damaged surfaces. Always use media with diameters smaller than the holes of your parts.

Traditional methods are laborious and inconsistent however spinner delivers faster cycle times and improved productivity. For high volume deburring needs order the edh sfs200 filtration system and 660 parts and media separator with your machine. Hand deburring small parts is often a tedious and labor intensive process let us reduce your company s overhead with this proven technology. You can also increase or decrease the deburring action by changing the diameter and length of media.

The revolutionary magnetic deburring process utilized by the spinner deburring machine has saved manufacturers tens of thousands of labor hours while producing parts free of damaged surfaces. Turn the spin frequency to about 1 2 power. Introducing the spinner machine a magnetic system for deburring and polishing small metal components. The spinner uses stainless steel pin media to remove light burrs and microburrs without harming the part.

Use 3mm length media for parts with small holes and crevices.